Myalarm V-LCD1 Manuale delle Istruzioni Scaricare il pdf (Pagina 71)

LCD PROGRAMMING INTRODUCTION

8-65

System 2 Installation / Programming Manual

CHAPTER 8

PROGRAMMING USING THE LCD

Introduction

The System 2 user interface hardware consists of a 24 character by two line LCD display and a

12 button Keypad. When in program mode, instructions and prompts are displayed on the LCD

and user responses are entered on the Keypad. Some basic features of program mode are:

Line 1 of the LCD scrolls instructions about the current option.

Line 2 of the LCD prompts the user for input.

Keypad button 1 serves as YES when a Yes-or-No question is asked.

Keypad button 2 serves as NO when a Yes-or-No question is asked.

Keypad button # is the enter key. If using a PC or VDT use the Enter or Return key.

Keypad button x is the clear key.

When entering a data item (like time, date etc.), LCD line 2 displays that item's current setting.

To change the current setting, just enter your desired data at the position indicated by brackets (

[--]), then press # (enter). To leave the current setting unchanged, just press # (enter).

All System events which occur during programming will not be displayed (because you are

already using the LCD display to program the system), but will be saved in the event buffer for

later retrieval if you so desire.

Keep it Simple

If you are new to the System 2, please do yourself a big favor: When it comes to installing or

programming this unit, "Please Keep it Simple". Until you really learn how this Electronic

Access Control System works, do only one thing at a time and then test it. Then, do the entire

installation that way. Thousands of hours and thousands of dollars have been lost by hundreds

of installers who just had to install and program everything "Right Now"... only to find out later

that they did it wrong and had to do it over.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 335 336

Nessun commento

Myalarm V-LCD1 Manuale delle Istruzioni Pagina 71