Myalarm V-LCD1 Manuale delle Istruzioni Scaricare il pdf (Pagina 107)

LCD PROGRAMMING - ADD/CHANGE CARDS

8-101

System 2 Installation / Programming Manual

Assign These Output(s) þþþþ

Outputs [ - - - - ]

Option Not Active! þþþþ

Press Any Key

Note: Although the display states the Option is Not Active, the output(s) have been assigned to the selected schedule.

However, it will not activate until the Second Door has been turned ON. Proceed to Option #13 to turn this Option ON.

The unit assigns this output to the user codes for those customers who wish to upgrade a one-door system (2003) to a two-

door system (2016) in the future, but do not wish to re-program the outputs.

Additional Outputs

When a valid card is entered, the door relay for that Port may be activated. In addition to this

activation, you might want other outputs to be activated to sound an alarm, trip a dialer, or send

some other signal. There are four such outputs from which to choose. The Program Aux

Outputs section of this manual details the physical properties of the outputs. Any, all, or none of

these outputs may be triggered by a user, if the Second Door is activated.

Refer to Option #13 to purchase this option.

The LCD will scroll the instructions:

Scrolling Options: to User ID

1=Aux Relay 1

2=Aux Relay 2

3=Voltage Output 1

4=Voltage Output 2

0=None

At the Outputs [ - - - - ] prompt, enter the desired output(s), if any, then press #.

Example: If you are programming the code 12345 and select Outputs 1 and 3, each time the

code 12345 is used the door will open and Aux Relay 1 and Voltage Output 1 will trigger...

provided you have installed a two-door System 2 (2016).

If you select any of these Outputs and you have not activated the Second Door the LCD will

scroll:

Scrolling Options: Install in Option 13

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 335 336

Nessun commento

Myalarm V-LCD1 Manuale delle Istruzioni Pagina 107