Myalarm V-LCD1 Manuale delle Istruzioni Scaricare il pdf (Pagina 62)

SYSTEM OPERATION

6-56

System 2 Installation / Programming Manual

Schedules that Cross Midnight

If a time schedule is required to cross the midnight hour, the schedule will appear slightly different than a

normal one. A good example is the 11:00 PM to 7:00 AM shift. This time schedule could apply to a group of

users, the relays or any of the available outputs.

This example is shown below:

SCHEDULE #4

CELL 1 DAYS OF WEEK

M T W T F S S 23:00

CELL 2 DAYS OF WEEK

M T W T F S S 07:00

Auxiliary Outputs

The System 2 has four auxiliary outputs that can be triggered from any system event. When the Second Door

is activated, user codes and time schedules can also trigger these outputs. These outputs can be momentary

(1-256 seconds) or latching on/off-on/off.

When operating the System 2 in network mode, an auxiliary output operates locally to each unit in the

network. This means that if you, for example, assign Aux relay #1 to trigger on a Door Ajar, Aux Relay #1

on the master will activate if the Door Ajar occurs on the master; Aux Relay #1 on slave #1 will activate if

the Door Ajar occurs on Slave #1, etc. This holds true for any other system event. Note: Some events

activate both outputs.

Clearing the Keypad

The x button should be used before entering a code on a Keypad. This will clear the Keypad buffer. After

the code has been entered, the # must be pressed to complete the operation. Using the # as an “Enter” key

allows various keypad code lengths of one to nine digits.

Keypad and Reader Operation

Keypads can be used along with any of the Reader technologies supported by the System 2. A Keypad and a

Reader may also be used together. When using a card technology, you must have similar reader technologies

on each System 2. The System does not support different technologies on the same unit. Example: If using

Data Chip on Door #1, and you wish to add another reader on Door #2, it must be a Data Chip reader.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 335 336

Nessun commento

Myalarm V-LCD1 Manuale delle Istruzioni Pagina 62