Myalarm V-LCD1 Manuale delle Istruzioni Scaricare il pdf (Pagina 168)

LCD PROGRAMMING - NETWORK OPTIONS

8-162

System 2 Installation / Programming Manual

Enter 1 thru 7

Slave to Add [ 0 ]

1=Yes, 2=No þþþþ

Reload Slave? [ 2 ]

Set Slave Box #

Enter Slave Num [ 0 ]

Unit is a Slave þþþþ

Enter Net Option [ 0 ]

Slave Number

If you choose to add a slave, the LCD will scroll:

At the Slave to Add [ 0 ] prompt, make your selection.

Reload Slave?

Now you have a choice to make. If this is the initial power up of your entire system (no

information has been programmed into the master) you do not need to reload the slave. As you

program the master, the information will automatically transfer to each slave - provided

communications has been established between the master and slave(s).

If you have added a slave to an existing system (one that has information already programmed

into the master) you need to send all previous programmed information to the slave(s).

Scrolling Options: 0=Quit

At the Reload Slave? [ 0 ] prompt, make your selection.

Slave Unit

If you chose to convert this unit to a Slave, the LCD will scroll:

At the Enter Slave Num [ 0 ] prompt, make your selection.

You can choose a number between 1 and 7. After your selection, you will be prompted.

Scrolling Options: 1=Make a Master

2=Make Standalone

3=Test RS485

At the Enter Net Option [ 0 ] prompt, make your selection. If you are finished, just press #.

You will return to the Main Menu.

If this unit is now programmed as a Slave, most of the Main Menu items cannot be accessed.

All programming must be accomplished using the Master.

1 2 ... 163 164 165 166 167 168 169 170 171 172 173 ... 335 336

Nessun commento

Myalarm V-LCD1 Manuale delle Istruzioni Pagina 168