Myalarm V-LCD1 Manuale delle Istruzioni Scaricare il pdf (Pagina 19)

100

101

QUICKSTART

2-13

System 2 Installation / Programming Manual

Quick Installation

U Remove all power from the unit. AC and standby battery.

U Run the wire. You'll need cables for the Reader or Keypad and Door Ajar switch, and a separate

two conductor for the door lock. Don't forget a pair for the AC power transformer, one for the

door lock power supply, and a wire going to a cold water pipe or electrical box for grounding.

U Mount the Keypad, Card Reader or Data Chip Reader. Keypads should be mounted at eye level.

Be sure if you are mounting a Keypad or Reader outside, that it is a weatherproof model.

U Mount the door lock and FOLLOW THE DIRECTIONS that come with it! Make sure to install a

diode across the coil for noise and spike suppression on DC powered door locks.

U Install the Request-To-Exit button and Door Ajar/Time Cancel switch. Don't run the Request-To-

Exit wires out to the Keypad or Reader. Drop them off inside the protected area.

U Make your connections to the System 2 and power it up.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 335 336

Commenti su questo manuale

Nessun commento

Myalarm V-LCD1 Manuale delle Istruzioni Pagina 19

Commenti su questo manuale

Prodotti e manuali riguardandi Sistemi di controllo di accesso Myalarm V-LCD1