Myalarm V-LCD1 Manuale delle Istruzioni Scaricare il pdf (Pagina 235)

PC/VDT PROGRAMMING - BATCH ENROLL DATA CHIPS

9-229

System 2 Installation / Programming Manual

The VDT will display the instructions:

01 03

Enter Door #

To Grant Access

Reenter Door #

To Deny Access

Enter Door (0=Done) [__]

The first line of the VDT will display the door(s) this group is allowed to access.

At the Enter Door (0=Done) [_ _] prompt, enter the next door this group is

allowed to access. When you are finished press 0 and ENTER. If you wish to change the door

permission at any time, reenter the number to deny access to a specified door.

Example: If you wish to “take door #3 permission away” from these users, enter door 3 again

and the permission will be denied.

If you select Port #3 and you do not have this System set-up for networking, the VDT will

display:

Error!

Entry Out of Range!

Press Any Key

To enable more than two doors, the Networking Option needs to be installed. Proceed to

Option #13 for installation instructions.

When you are finished entering door numbers press 0.

Seed Number

What is a Seed Number? Here’s an example: You select a seed number of 1000, Batch Enroll

200 users, and use the System for months or years. One day, someone accidentally erases

memory. Now everyone’s codes are erased. No problem! When Batch Enrolling Users again,

simply select Seed Number 1000 again, and the System will assign the identical codes it did

previously, saving you time of issuing new numbers, and users the aggravation of memorizing a

new code number.

The Seed Number must be four digits. Again, you may not use Leading Zero’s.

Note: This prompt will only appear if any of your ports are selected as Keypad Only.

Remember, the system default is for Keypad Only. If you have the network option active and

any of the eight or sixteen ports have not been changed to Card Only (if this is what you

desire), you will have to enter a seed number here. If you do not intend to use Keypads on

your system, exit this option and return to Option #5 - Port Configuration and set all

your ports to Card Only.

The VDT may display the instructions:

Use 4 Digits

Enter Seed # [____]

Enter your four digit seed number and press ENTER.

1 2 ... 230 231 232 233 234 235 236 237 238 239 240 ... 335 336

Nessun commento

Myalarm V-LCD1 Manuale delle Istruzioni Pagina 235